A place to where I can record my Technical stuff that should be accessible from anywhere. It is mainly technical stuff I find interesting and I suppose it can be looked on as a modern Lab-book.
M3 S1 then delay 5 Seconds to allow spindle spin up G4 P5.0 and for turning spindle off. M3 S0 For milling PCBs I added these g codes to the software FlatCAM Options Tab. Prepend to G Code M3 S1 G4 P5.0 and Append to G Code M3 S0 This then means when the G Code is generated from my PCB design at the beginning of the job the spindle will spin up wait 5.0 Seconds start milling and finally will stop the Spindle at the end of the job. This hopefully will reduce the wear on the spindle by only having it on when